Quote Originally Posted by ptjeff1 View Post
My first thought is that it is a sticking solenoid for the tray 2 pickup assembly, not the paper size pca.
I have been using the printer since the reply, mostly without problems.

When I change the paper or open the paper tray, I have to turn the printer off first.

Then I can remove the paper tray and work with the paper as necessary.

Then I have to get down on my knees and wiggle the three switch fingers on the inside right side of the printer,
make sure the paper-size projections on the paper tray are properly actuated by moving the back paper stop forward,
and then slowly reinsert the paper tray.

When I do that, it works most every time. Once it is working, I never have any more problems.

So, as I asked originally, how do I remove all the outer panels, separate the top half of the machine from the lower trays,
and then remove the top plate covering the lower trays to remove & work on the PCA board?

Thanks,


Craig