HP DESIGN JET 800 PS Question

[Phillytech1]

How do you install the encoder strip?

[redcow]

Do you know how to remove the strip?

[Phillytech1]

No our last tech quit last week. The printer is disassembled. He just up and left. He just left the parts on the table. The service manual is vague when it comes to the encoder strip install.

[redcow]

I'll get you the info later...I have to go to work now.

[redcow]

email me and i'll send you the pages from the manual

[Phillytech1]

Got the encoder strip installed. Here we go


1. replaced the aersol fan/service station
2. lubricated the roller
3. Installed new carriage assembly


After all that, there is still an 86.01 error.


Any suggestions?

[redcow]

System Error: 86:01
Problem
Description:
Carriage-Axis shutdown.
Corrective Action: If this error code appeared but was NOT caused by a paper jam, then
try the following:

Too much friction in the Slider Rod. Enter the Printer Information
utility (⇒ Page 4-27) and check the Scan-Axis usage. If the
percentage is close to 100%, then lubricate the Slider Rod.

The Carriage is bumping into the Service Station. If the carriage
is stuck at the right hand side of the Printer and cannot be moved
out to the center of the Print Platen it is because the Service
Station cannot uncap the Printheads. In this case replace the
Service Station/Aerosol Fan Assembly ⇒ Page 8-52.

Perform the Carriage Movement test ⇒ Page 4-8.

[Manuals]

Get a new tech.