Results 1 to 2 of 2

Thread: HP Laserjet 1320

  1. 02-17-2011, 05:36 PM #1
    UtahTN
    UtahTN is offline Junior Member
    Join Date
    Feb 2011
    Posts
    1

    Default HP Laserjet 1320

    When printing from a PC or doing a test print, the 1320 picks up the paper okay and starts printing the test page and then stops with about 2 inches of the paper visible in the output bin. It would only need to advance the paper another 8 inches to finish. The attention light is flashing / blinking. The paper is warm and the toner is fused to the paper. If I pull the paper out and turn off and then on, the printer will pickup and feed a blank sheet into the output bin just fine. But if I test print again it will stop with the paper visible in the same place every time and the attention light comes on. I have about 50 sheets of paper in the paper tray. The printer is not jamming in anyway. FYI: I did try a factory reset to default settings but no change.
    Last edited by UtahTN; 02-17-2011 at 06:03 PM.
    Reply With Quote Reply With Quote
  2. 02-22-2011, 11:17 AM #2
    cs_steve
    cs_steve is offline Super Moderator
    Join Date
    Dec 2006
    Posts
    737

    Default

    Most likely the fuser. Is the page smudged when you pull it out?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules