Hi

I have just joined this forum and would like to say a big hello to everyone!

I haven't seen any threads on Konica printers but its worth a go. The konica Minolta 451C bizhub should be able to do full bleed and nearly edge to edge printing. However I am struggling to achieve this, I alway end up with a 6mm left margin. I can use Image shift in the driver to get the margins equal. This however results in some of the left of the document being cut off at the 6mm left margin. I think it could be down to a binging left margin but I have tried all the combinations to adjust this to no avail.

If anyone has every came across this issue or better still has a solution I would love to here from you.

Thanking you in advance

Stewart