6P printer problem.

[woodss]

I have a 6P printer that has a 50 Service error, lights come on after shuting down, it has melted rear gears which is a sign of overheating however this printer when i obtained it from ebay it was working after turning it off and turning it back on after 15 minutes it decided not to warm up the fuser.

What can it be the DC Controller or the heater element?
Will the printer blow the replacement element?

[redcow]

50 - FUSER ERROR

Temporary error code, turn printer off then wait 20 or 30 minutes to turn back on
Low or unstable power- Check the wall voltage, if on a surge protector, plug straight into the wall
Bad Fuser Assembly
Bad Low Voltage Power Supply
Bad DC Controller
Improperly seated Fuser
Defective Fuser
Bad Engine Controller Board

[woodss]

It turned out to be a bad defective fuser element assembly on the printer, as soon I replaced the element assembly the printer worked, and also replaced the back output rollers on the fuser as well.

The DC Controller isnt faulty, it works well.

Thanks
Stuart.