HP 4050N & JetDirect 600N J3113A Problem

[initiate497]

I just installed a JetDirect 600N J3113A in my HP 4050N. How can I set its IP? The printer's control panel only gives me the option of turning TCP/IP on and off, etc.

I tried using JetAdmin, but it will not go into the new devices to configure it, and HP Download Manager won't detect it to update the firmware.

Here are the general information on my Config Page:

HP JETDIRECT J3113A
FIRMWARE REVISION: G.08.32
LAN HW ADDRESS: 0030C10234E1
PORT SELECT: RJ45
PORT CONFIG: 100TX FULL
AUTO NEGOTIATION: ON
MFG ID: 39463946900719
DATE MANUFACTURED: 11/99
I/O CARD NOT READY: 59
INCOMPLETE F/W -MUST DOWNLOAD

PROTOCOL INFORMAITON

SNMP SET CMTY NAME: NONE
TCP/IP STATUS: NOT IN USE

Any help on how to set the IP address so I can set it up on the network would be greatly appreciated.

Thanks

[ptjeff1]

Turn TCP/IP on, and go to config TCP/IP, hit select, then in the sub-menu make sure BootP=NO, then you can set the IP and subnet mask. BootP=Yes will make the card search for a bootp or dhcp server.