Service Manuals

[lhancock]

Suppose I'll start this one up again from the old forum

I'm looking for service manuals for the following:

Laserjet 5000n
Laserjet 1000
Laserjet 4Si
Designjet 430

Any help would be appreciated :D
________
roll a joint (http://howtorollajoint.net/)

[ptjeff1]

Just an FYI, PDF files of service manuals are almost always selling on ebay for around $10-$20. The CDs usually include almost every HP printer service manual on the disk.

[KKDJC]

Me too, Repeat request from previous forum.

Service Manual for HP IIP

Can anybody help in locating a service manual for the LaserJet IIP? I found manuals for many later models but none for the IIP itself. Any assistance would be greatly appreciated. Unfortunately the IIP is different from the II, and III. I am specifically looking for the voltage levels from the High voltage power supply. The manuals normally say replace if it does not work, but they do not tell you what the measurements should be.

lhancock, try this link http://www.snami.by/index.php/.49....0.0.0.html, there I found manuals on the 1100, 2100, 4000, 4050, 4500, 4m, 4mp, 5p, 5mp, 5si 5&6l, 5000, and the ii and iii. Good luck, I hope I get similar feedback.

Regards.
KKDJC

[Ratpuppy]

THANK YOU KKDJC!

I have also been searching for HP manuals... Have a LaserJet 6p with a 50 code. Got the rebuilt fuser, have the cover off, but didn't want to break that old one removing it... (Have to send it back...) That cheesy Russian PDF of the 5p manual was close enough for me to get the job done without tearing out either the fuser or my remaining hair!

Thanks again.


Me too, Repeat request from previous forum.

Service Manual for HP IIP

Can anybody help in locating a service manual for the LaserJet IIP? I found manuals for many later models but none for the IIP itself. Any assistance would be greatly appreciated. Unfortunately the IIP is different from the II, and III. I am specifically looking for the voltage levels from the High voltage power supply. The manuals normally say replace if it does not work, but they do not tell you what the measurements should be.

lhancock, try this link http://www.snami.by/index.php/.49....0.0.0.html, there I found manuals on the 1100, 2100, 4000, 4050, 4500, 4m, 4mp, 5p, 5mp, 5si 5&6l, 5000, and the ii and iii. Good luck, I hope I get similar feedback.

Regards.
KKDJC