Hp 8100

[Old Printer Tech]

Getting Erroe 50.1 error.. Changed the Fuser and DC Controller. No Change...

Any suggestions?? Thanks OPT

[hai]

OPT,

Before you go on to change the laser/scanner assembly, clean the registration assembly. Good luck!

Hai

[Ubermike]

Please ignore the previous post as the 50.1 has absolutely nothing to do with registration or the scanner. Its an error stating the fuser is not reaching the correct temperature and I'm sure you knew this since you replaced the fuser.

Make sure the outlet its plugged into doesn't have another large device on it that could be drawing power away. Most outlets have 15 amps and these take 12-13 amps to run.

Low Voltage Power Supply would be the next part to replace. In the future though I would use this order to replace parts after checking site power for the 50.1: Fuser, LVPS, FIxing cable assembly, DC Controller. DCC is usually never the cause so should be a last resort fix.

[Old Printer Tech]

The low voltage power supply did the job thanks for the good advice

OPT