Big Al
01-18-2013, 12:01 PM
177This printer only had 2,300 pages on it when it came back to the shop. It would print a page just fine but the fuser was not turning so the page would be folded up between the toner cartridge and the fuser input roller. The swing plate was not working because the clutch disk was contaminated with factory grease. I'm not sure if the factory put on too much grease or if vibration during shipment moved it up there. I tried depressing the clutch plate and cleaning it with solvent. That worked a little bit better but not good enough. Finally I pushed the lower plate down with a small screwdriver and gently cleaned the disk with #400 sandpaper. All is well again!
Al
Al