re-mounting Transfer Guide Assembly?

[jariep]

I would like to remount the Transfer Guide Assembly on a HP Laserjet III.

Are there any instructions on how to do this?

I went to the following URL for a diagram:

www.printerworks.com/Catalogs/SX-Catalog/351SXTransGdAssbly.html

I am only having difficulty with "support, shaft" ra1-4323-000 (it is made of brass). It turns a full 360 degrees and I don't know in what position it goes installed.

I had to remove the Transfer guide Assembly from the laserjet (the entire assembly I removed with only 2 screws) because there was a piece of broken plastic inside that was jamming the paper, which I removed with a vacuum cleaner using a suction hose.

I am not a very technical person and I don't have an experience on working with the internals of hp laserjets, but I managed to remove this piece and, also, replace ra1-3826-040 without too much difficulty. This and ra1-3825 is where the broken plastic fragments came from that got stuck in the Transfer Guide Assembly.

Anyhow, all I need to do now is re-mount the Transfer Guide Assembly, I need some instructions on how to do this, preferably with a diagram, if possible.

Note: I can re-mount the Transfer Guide Assembly without much difficulty, I am just unsure of the position of ra1-4323, as this brass component turns a full 360 degrees and not sure in which of two positions it goes when seeting the entire Transfer Guide Assembly.

I sincerely appreciate any help you may provide.