jdsm48
12-30-2010, 04:07 PM
I have been working on a HP 2200. Works fine out of bypasstray. When using Tray 2,
prints will stop about and inch out of exit unit at top rear of printer, and second print is stopped under toner cartridge on top of registration assy.
I have replaced the Tray 2 PU assembly unit, swapped fudse with another HP 2200 on site,open rear door to see if it is the exit rollers, top rear. Still jams out of TRay 3 no matter what I've swapped,replaced. Any suggestions?
prints will stop about and inch out of exit unit at top rear of printer, and second print is stopped under toner cartridge on top of registration assy.
I have replaced the Tray 2 PU assembly unit, swapped fudse with another HP 2200 on site,open rear door to see if it is the exit rollers, top rear. Still jams out of TRay 3 no matter what I've swapped,replaced. Any suggestions?