Question on HP LJ5500

[jsilva67]

Replaced Cyan Laser due to a 52.1C error code. I ran calibration procedure and printer started working but the Cyan and Yellow colors were not aligning with the Black and Magenta colors. I cleaned the EBT sensor and the EBT has been replaced within the last 9 months. I reset to factory settings and then I got the original 52.1C error code again. Any suggestions on what to do next? :confused:

[cs_steve]

- Try several more calibrations in a row, sometimes multiple calibrations are required ...
- Check connectors to DC controller for that scanner
- Replace scanner again, or replace DC controller

[MichaelTech]

You might also want to update the firmware, even if same.

[printerguy]

Off the bat, If the supplies in the machine are not OEM HP brand, I would start there.
or
look up the "nv ram init" procedure...
I have solved some really weird problems by doing this.

Good Luck

[jsilva67]

Thanks for the info. I will try your suggestions.
- Try several more calibrations in a row, sometimes multiple calibrations are required ...
- Check connectors to DC controller for that scanner
- Replace scanner again, or replace DC controller

[jsilva67]

Thanks for the info. I will try your suggestions.
You might also want to update the firmware, even if same.

[jsilva67]

Thanks for the info. I will try your suggestions.
Off the bat, If the supplies in the machine are not OEM HP brand, I would start there.
or
look up the "nv ram init" procedure...
I have solved some really weird problems by doing this.

Good Luck

[aprces]

i've also got a HP printer that is out of control, the phenomenon is once i want to print something, it splashed a window warning me i have a software device uninstalled, but when i put the CD in and install it, it told me there is something wrong with it then re-uninstalled

http://cartridgebuys.com/