dimm
02-23-2009, 06:59 AM
Display error message: "Ensure Printhead Latch is properly closed"
The problem was that the holder below the printhead had come loose from the printhead driver ribbon.
Remove the left, right (four screws) and top covers (four screws), and loosen the steel guide with two screws and you can tilt the printhead.
Attach the parts.
The problem was that the holder below the printhead had come loose from the printhead driver ribbon.
Remove the left, right (four screws) and top covers (four screws), and loosen the steel guide with two screws and you can tilt the printhead.
Attach the parts.