View Full Version : HP 5si Maint. kit
stevemcc
01-13-2005, 09:57 AM
Hello all,
New to this forum. Was wondering if anyone has ever installed the maint. kit for the HP 5si and how long it took. Any help would be appreciated.
Thanks, Steve
Open left door, remove the duplexer if installed. Remove the fuser (there are 2 blue lever locks at ends- turn them to vertically to unlock from horizontally position-locked). Install new fuser, lock it with same blue levers. Open top door, remove toner cartridge, then remove the old transfer roller. Be carefull, there are 3 springs under that transfer roller. The 2 regular springs should still be in position when removing transfer roller, but the thin copper spring(?) sometimes jerk out of it position. Install new transfer roller then replace pick-up, feed and separation rollers(provided w/new kit) if needed. Good luck! Hope the instruction is clear enough.
ptjeff1
01-15-2005, 06:43 AM
Instructions here http://www.printertechs.com/tech/mkinst/mk-5si8000-1.php
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.