tmeppen
03-17-2008, 10:23 AM
Hopefully someone can help me out here.
I'm working on a HP2300dtn. Originally just the fuser needed to be replaced. So I did that but I figured I should change the rollers and seperation pads at the same time so that i wouldnt have to deal with it later. the fuser works fine now but its not picking up any paper from tray2.
-It gives me a 13.xx.xx code that says tray 2 is jammed. I open it up but theres no jam. I thought maybe I had the paper senser in wrong so I moved it all the way to the right and then it said tray 2 was empty so I know I had it in the right place originally.
-If i set the printer to print from tray 3 it prints fine. However it makes a weird grinding noise if i take all the paper out of tray 2 and print from tray 3. Theres no unusual noises if tray 2 is full and it will print fine.
I'm working on a HP2300dtn. Originally just the fuser needed to be replaced. So I did that but I figured I should change the rollers and seperation pads at the same time so that i wouldnt have to deal with it later. the fuser works fine now but its not picking up any paper from tray2.
-It gives me a 13.xx.xx code that says tray 2 is jammed. I open it up but theres no jam. I thought maybe I had the paper senser in wrong so I moved it all the way to the right and then it said tray 2 was empty so I know I had it in the right place originally.
-If i set the printer to print from tray 3 it prints fine. However it makes a weird grinding noise if i take all the paper out of tray 2 and print from tray 3. Theres no unusual noises if tray 2 is full and it will print fine.