PDA

View Full Version : Hp P3005dn



redbirdron
03-07-2007, 03:24 PM
The Control Panel Doesn't Give A Read Out Everytime It Is Switched On, When It Does Give A Read Out It Gives A 49.0? Error Code, Or It Will Get Stuck On Initialization, Or Goes Blank Then Coems Back On Again, Or Says There Is A Problem With "dimm"
I Have Ordered New Manuals , But Have Not Received.

redcow
03-08-2007, 01:49 AM
It's a firmware error.
Book says to power cycle printer.
I would guess that you already did that.

I would remove the formatter, reseat the DIMMs, put them back from whence they came, reinstall the formatter and power up. If it fails again with 49.xxxxx, remove the memory DIMM (if you have one)(don't touch the firmware DIMM) and power it up.
If it still fails..most likely the firmware. If it runs...most likely the memory.

We're assuming here that the printer has added memory.