HP laserjet 1160

[Don]

I have a LaserJet 1160 that upon power on it starts feeding paper till it jams, on either page 2 or 3. Clear the jam close the doors and the cycle starts again. I went through about 30 sheets before my patience ran out. I have removed the sides and top and bypassed the door switch so that I can see what is happening and it appears that the paper is feeding too fast.

Any thoughts let me know.
Thanks

Don Rinear

[leah]

If the pages it prints are black there is probably a problem with a clutch, causing a pickup roller to constantly spin. Check the plate on the clutch to see if it is seated properly.

[woodss]

Its not probably that is the clutch, it is the clutch causing the problem, this problem was common in the laserjet II which is a older printer, if the pickup roller shaft is not properly installed then it will cause those problems.

Reinstall the pickup roller and replace the clutch, and your be fine then.