It was the power supply that was at fault
Type: Posts; User: spike1496
It was the power supply that was at fault
This printer posts up to and including message " genuine HP cartridge installed", then stops with "install black cartridge"!! I have replaced DC controller (twice)cartridge sensor,...
Right before the paper enters the print position, there are 3 sensors the first in the centre to detect the leading edge and then a left and right flag to detect registration is true. I have a...
Thanks..I replaced the power supply, and now I have a solid 50.09 error!! Replacing the fuser 3 times didn't affect it one bit ??
I have a message of 'Install black cartridge', even after trying multiple cartridges.. I replace the cartridge sensor in the "roof" but that didn't help..Any ideas??
I have 2 units with broken transfer roller retainers on the right side. I can't see how to replace that part (I have a manual)..Any ideas??
I have a HP4015 which I cannot reset the "replace maintenance kit" message. I have done a cold reset twice.
Also......There is no paper jam..The print cycle is completed and the page is fed right through before the error is displayed..Thanks for your help..
The gear is not cracked..Are you referring to the sensor ps102 ?
Tray1 & 2 are set to "any" size..Did as you suggested..No problem from tray 1..Then from tray 2..It prints 6 copies then stops with the "size mismatch" error followed by "41.3 unexpected size in tray...
This unit prints a few pages before this error appears. I am using a brand new tray..I have replaced the size sensor unit, the DC controller. Any ideas ??:
When trying to duplex,the first cycle prints the first side, but paper stops in the duplexer before proceeding to the transfer roller for printing the back side..?
Thanks Al...I found the answer (DC controller) at the HP website..
I have one with 68.2 error. "permanent storage write fail". Printer wont come ready. Have tried formatter.
Thanks for your interest.. I did manage to pop put the rollers without losing any( I taped the small ones together so they wouldn't pop out!) and replace the belts. How did you get the manual?
Does anyone know how to replace the "bed plate" containing the 3 belts or an easy way to replace the belts which wear out ?
There is a locking tab on the exit paper delivery assy. I have ordered the assy. 3 times, but it does not include this piece. Anybody know what the part number for this might be ??
I think I have figured it out..There is a spring in the lift assembly that the motor drives, and it appears to be too weak to return the tray lifter to 'home position'. Consequently when the tray is...
I've got a "60.02" error that wont clear.(Book says it's to do with the paper lift operation).Iv'e tried another tray.. Any ideas??