if your using more than one tray for any particular document.go to the driver printing preferences /paper quality tab and to special pages.where you can set the source for front and back...
Type: Posts; User: raz
if your using more than one tray for any particular document.go to the driver printing preferences /paper quality tab and to special pages.where you can set the source for front and back...
is it happening with test pages directly from the printer as well as jobs sent to it?
right ,or disable the cartridge check in the diagnostic menu and remove the cartridges one at a time and try.if you open the cartridge shutters and look in on the drum area ,is there any toner in...
you could possibly try to click the page option at the top and switch the encoding.
guys above are probably right.there is a chance that when the lightning caused a surge in the line,that the low voltage power supply circuit fuse tripped to protect it and shut down any path for the...
it could be that the carousel has jumped out of alignment and needs reindexing.this is a common issue with this type of printer.this forums attachment limit is too small to post instructions.if you...
someone has mentioned that they need cleaning with a brother MFC 4150c.i have not heard of this model and i looked on the brother site and there is no mention of this particular model number.i am...
is the printer still under warranty?
a half stop test would be;start a print from tray 1 and when the trailing edge of paper is just entering the machine,open the cover to stop print.take out the cartridge and open it's shutter and see...
if it is not listed on the configuration page then the printer is not recognizing it and it would be a problem with the connection between tray 2 and 3.the contacts on the housing are either bent or...
the new swingplates or gear replacement kits usually come with a spacer disk to prevent this .if it is a swingplate and you take out the fuser you should be able to see if the gear is worn.often...
do you have a hard disk on there?if so ,you could try a hard disk initialization.which would be powering on and when the memory count starts,press and hold the menu button until the led's flash then...
if it's just a 50 error.then it would refer to a fuser error.generally the fuser is overheating or underheating.in most cases the fuser has to be replaced .sometimes if there is an issue with a power...
have you tried any different drivers?
i would think not either,though i suppose it's possible.for one thing though ,the 1500 has a host based formatter.where the 2500 has a page description language formatter.also,the 1500 has USB...
could be an issue with the fuser drive motor.just when reversing.
it seems like the power supply is working ;the control panel lights are controlled by the formatter /firmware.if you press the go and job cancel buttons,does it print a configuration page?
...
will it print an engine test?button is in the upper left frame inside tray 1.engine test would print from the last tray used on a regular print job.if it prints ,i would think that it is something...
:D not that it would be funny,but it seemed almost schizophrenic.
looking at the front of the printer.it should be on the right side cover,about the lower middle ,just below the fan grill.
usually if a flag is jammed or stuck out of position it will show a jam right away.that may be why it goes in to the paper path check right away.the main paper path sensors are right by the...
could be something wore out or not working proper with the fuser causing some slippage.try telling the printer to use a different paper type from the tray you are printing. selecting different paper...
if you originally installed it from the cd and did a full install it may have installed all the drivers,or at least the PCL6 and PCL5e.i don't know if you could remove and reinstall the drivers via...
i would say,some kind of driver/application conflict.have you tried a different driver?
i don't know if there would be any particular set lifetime page count.printer lifetimes vary and with a total page count,there are many different components that are involved.